MustangWorks.com : Ford Forums - View Single Post - Polishing on a GT-40 intake and a set of Cobra R's

2FastLX · 11-07-2001, 05:01 AM

mustang928 - Did you do that? The first thing out of my mouth when I saw the pic was "OH MY GOD!". That is killer. That's what I want mine to look like, but I want red between the fins. I already smoothed the lower out a bit before I installed it, but it still needs a ton of work.

chatcher - Here's a good link for you... http://www.geocities.com/MotorCity/P.../polishin1.htm
Aircraft stripper can be found at Auto Zone or Advance Auto parts stores. You might even find it in hardware stores. It works great for peeling powder coating off, and you won't have to use the coarse git sandpaper so it will take a lot less work to get the finish ready for buffing and polishing.

[This message has been edited by 2FastLX (edited 11-07-2001).]

11-07-2001, 05:01 AM	#7
2FastLX The Photoshop Guru Join Date: Feb 2001 Location: Mecca, Indiana Posts: 1,419	mustang928 - Did you do that? The first thing out of my mouth when I saw the pic was "OH MY GOD!". That is killer. That's what I want mine to look like, but I want red between the fins. I already smoothed the lower out a bit before I installed it, but it still needs a ton of work. chatcher - Here's a good link for you... http://www.geocities.com/MotorCity/P.../polishin1.htm Aircraft stripper can be found at Auto Zone or Advance Auto parts stores. You might even find it in hardware stores. It works great for peeling powder coating off, and you won't have to use the coarse git sandpaper so it will take a lot less work to get the finish ready for buffing and polishing. [This message has been edited by 2FastLX (edited 11-07-2001).]