I went with Hedman. They were around $150.
I think the biggest pain was putting the new oil pan on. The motor came with the dipstick in a housing attached directly to the oil pan. It was a 2 sump and I had to replace it with a front sump. I therefore had to drill out the dipstick housing, cut a hole in the new oil pan and mount it. After all that I went to put it on the engine and came to see that the housing bumped against the oil pump. So, I had to switch sides and was left with a hole in one side of the pan that I had to get welded.
I had to buy a flat fan without a clutch to have radiator clearance.
Can you suggest a place to put an electric fuel pump? I'm going to replace all the metal line with rubber and have to come up with a good place to mount it.
|