You can lower the front more by just cutting 1/4 turn off the coil spring. On my 620's in my '66 coupe, this lowered the front another inch. My advice is to use a cut off wheel on a die gringer to cut the spring rather than a torch. Be careful with the spring compressor when removing the spring.
Rev
------------------
'66 Coupe, 306, windage
tray, TRW flat tops, 351W
heads,pocket ported, 268
CC hydraulic cam, R tip
R's, Edelbrock Performer,
600 CFM Holley vac. secs.,
Mallory Unilite, coil, fuel
pump, Tri-Y headers, 2 1/2 "
custom pipes, 3 chamber
Flows, stock C-4, 3.25
Currie built 8" rear,
March under drive pulleys,
13.97 e.t., 100.1 mph
1/4 mi.
|