I'm putting together a new engine/trans combo. I have a late model 302 with 10 1/2
inch motorsports clutch. I used the troughout
bearing that came with the clutch kit. I'm
running the stock z bar clutch linkage. With
the adjustment all the way tight i only get
about 2 inches of clutch movement. The clutch
falls to floor, actually moving the clutch
about the last 2 inches. Has anyone heard of this problem? Do i need a different troughout bearing or longer adjustment rod? Any thoughts?
Regards,
Billgear
www.289mustang.com
1966 Mustang Coupe