MustangWorks.com : Ford Forums - View Single Post - I will spend $900 tomorrow... suspension&raceseats...

Skyman · 02-06-2001, 07:55 PM

Ok guys, I have exactly $900, nothing more. I want to once and forall get my suspension done. That means new springs, and struts and some traction bars or something of that nature.

I also need 2 race seats fully equipped. That means mounts, coverings etc. I figure these will be about $150 each fully assembled. So that leaves $600 for the suspension.

I am also going to have to have the springs installed somewhere so money has to be left over for that. Anyone know how much that will cost?

Also any recommendations on the race seats? I know they wont be as comfortable as my Saleen seats now, but I want something fairly decent.

Thanks,

Skyler

------------------
-1989 Saleen Mustang #406-
TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft.

Added: B&M Ripper, Subframes, & Turndowns.

02-06-2001, 07:55 PM	#1
Skyman I need 110mph Trap Speed! Join Date: Feb 1999 Location: So, CA Posts: 4,315	I will spend $900 tomorrow... suspension&raceseats... Ok guys, I have exactly $900, nothing more. I want to once and forall get my suspension done. That means new springs, and struts and some traction bars or something of that nature. I also need 2 race seats fully equipped. That means mounts, coverings etc. I figure these will be about $150 each fully assembled. So that leaves $600 for the suspension. I am also going to have to have the springs installed somewhere so money has to be left over for that. Anyone know how much that will cost? Also any recommendations on the race seats? I know they wont be as comfortable as my Saleen seats now, but I want something fairly decent. Thanks, Skyler ------------------ -1989 Saleen Mustang #406- TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft. Added: B&M Ripper, Subframes, & Turndowns.