MustangWorks.com : Ford Forums - View Single Post - Will I see 340-350FWHP with this combo, please respond

Skyman · 02-06-2001, 11:46 PM

I dont think you'll have a problem at all.

Eric's car there is making 289rwhp with the same heads as me.

My car weights about 200lbs more than him, and I'm trapping about 106mph also, so Im probably around 300rwhp. We both only have about 9:1 compression. Your going to have 10.5:1 and only weight 200lbs more than me.

Also my run was made on a 105degree day, and I have no clue as to tuneing. I was running 38psi fp and 23 degrees of initial timing.

Skyler

------------------
-1989 Saleen Mustang #406-
TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft.

Added: B&M Ripper, Subframes, & Turndowns.

02-06-2001, 11:46 PM	#24
Skyman I need 110mph Trap Speed! Join Date: Feb 1999 Location: So, CA Posts: 4,315	I dont think you'll have a problem at all. Eric's car there is making 289rwhp with the same heads as me. My car weights about 200lbs more than him, and I'm trapping about 106mph also, so Im probably around 300rwhp. We both only have about 9:1 compression. Your going to have 10.5:1 and only weight 200lbs more than me. Also my run was made on a 105degree day, and I have no clue as to tuneing. I was running 38psi fp and 23 degrees of initial timing. Skyler ------------------ -1989 Saleen Mustang #406- TFS Heads, Edelbrock intake, E-303, 3.73's, 1 5/8 shortys, Offroad-H, 2chamber flows, 36psi FPR, 15degrees timing, 70mm tb, 73mm maf, 24lb inj, Crank pulley, MSD6A, Alum driveshaft. Added: B&M Ripper, Subframes, & Turndowns.