MustangWorks.com : Ford Forums - View Single Post - Chambersize and comp (stock heads)? and mill??

ponypower · 02-10-2001, 10:24 AM

with KB Silvolite 110 pistons, .030 over bore and stock heads milled .055 you will have around 10.5:1 compression. this is my setup. if you mill anymore than .055 you have to mill your intake to make up the difference. if you go less than .055 the intake will not be affected. i run pump gas 93 octane.

good luck

------------------
90 LX, LOTS OF EXPENSIVE TOYS, FRESHLY REBUILT THIS WINTER, RAN 13.10'S LAST SUMMER, LOOKING FOR 12.80'S THIS YEAR. THAT'S WITH AN AOD, DAILY DRIVEN
PonyPower
<A HREF="http://www.mustangworks.com/cgi-bin/ViewIt.cgi?http://www.mustangworks.com/cgi-bin/moi-display.cgi?269" TARGET=_blank>1990
Mustang LX</A>

02-10-2001, 10:24 AM	#5
ponypower Registered Member Join Date: Mar 1999 Location: Fayetteville, NC Posts: 206	with KB Silvolite 110 pistons, .030 over bore and stock heads milled .055 you will have around 10.5:1 compression. this is my setup. if you mill anymore than .055 you have to mill your intake to make up the difference. if you go less than .055 the intake will not be affected. i run pump gas 93 octane. good luck ------------------ 90 LX, LOTS OF EXPENSIVE TOYS, FRESHLY REBUILT THIS WINTER, RAN 13.10'S LAST SUMMER, LOOKING FOR 12.80'S THIS YEAR. THAT'S WITH AN AOD, DAILY DRIVEN PonyPower <A HREF="http://www.mustangworks.com/cgi-bin/ViewIt.cgi?http://www.mustangworks.com/cgi-bin/moi-display.cgi?269" TARGET=_blank>1990 Mustang LX</A>