MustangWorks.com : Ford Forums - View Single Post

86GT · 03-28-2001, 03:07 PM

Anybody wanna guess what I may make for power? I'm not gonna dyno it for a few more weeks though, so I won't know til then.

My combo:

Edelbrock 6032's (1.90/1.60) Performer,
Performer 5.0 intake with gasket matched lower,
3/8" Phenolic Spacer,
24lb injectors, Accel FPR, 190lph pump,
302 Rebuilt bottom end with windage tray,
High Volume oil pump, hd shaft,
F-303 Cam,
1.6 Roller Rockers,
65mm t/b (going to a 70mm in a couple weeks),
73mm C&L Mass Air Meter,
K&N Filter and homemade ram air,
Short belt (alt, water, p/s, pullies),
1 5/8" Mac Longtubes, 2 1/2" Catalytic pipe, catback.
I think that's most of it...
I'm told I should make around 320hp at the flywheel..

[This message has been edited by 86GT (edited 03-29-2001).]

03-28-2001, 03:07 PM	#1
86GT Sniffed too much n20 Join Date: Oct 1998 Location: Ont, Canada Posts: 1,018	Horse Power Guesstimate Anybody wanna guess what I may make for power? I'm not gonna dyno it for a few more weeks though, so I won't know til then. My combo: Edelbrock 6032's (1.90/1.60) Performer, Performer 5.0 intake with gasket matched lower, 3/8" Phenolic Spacer, 24lb injectors, Accel FPR, 190lph pump, 302 Rebuilt bottom end with windage tray, High Volume oil pump, hd shaft, F-303 Cam, 1.6 Roller Rockers, 65mm t/b (going to a 70mm in a couple weeks), 73mm C&L Mass Air Meter, K&N Filter and homemade ram air, Short belt (alt, water, p/s, pullies), 1 5/8" Mac Longtubes, 2 1/2" Catalytic pipe, catback. I think that's most of it... I'm told I should make around 320hp at the flywheel.. [This message has been edited by 86GT (edited 03-29-2001).]