Im sure there are some in Knoxville I just refuse to change.
"Whites Performance & Machine" is where I get my block/heads worked.
They are located between Kingsport And Bristol. "East Stone Drive" (423) 288-3881.
They have started to sell rebuilt motors with 3 year 100,000 mile waranty on them also.
They just finnished a friends Bowtie, 800 plus HP...
I work for Jefferson City.
Skeen machine in Jefferson City does a good block prep/ balancing etc. They do not assemble motors though. But I can find somone to put it together if you need.
Skeens" .30 over bore,turned crank,/resize rods-push on pistons/balance entire rotating assembly will set you back @ $ 500.00. minus your parts. Then start on the heads.
I live in Kodak. I am not familiar with any good machine shops in K-Town. However there are a few good High Performance parts shops in K-Town.
K-Town @ 1 mile south off of 640 on Broadway Blvd. The owner of "Hot Rod Barn" lives in Dandridge. Hes a nice old man.
Mail me if you need anything else.
|