Quote:
Originally posted by 88workcar:
My turn  You all know I have been here quite some time. I have been questioned about my time slips and just what my car can do. What I would like to know is this. How much power do I have at the flywheel? I showed a best of 339RWHP. This is with a very simple combo. 65mm TB, B-303,cobra, (bottom ported by me), Edelbrocs (decked.020), 1 5/8 long tubes, race pully, 1.6RRs, tremac, 4.30s, and old hard MTs 26 x 10s. Launch at 3500rpms, shift at 6000. This yielded a 12.17 @112, 1.72 60ft, fronts off the ground. And with a speed density computer. I also hit the 100hp NOS and missed fifth gear after spinning and letting off out the hole. This yielded an 11.72 @ 116 with a 1.87 60ft. This was all done on a stock bottom end with 90,000 miles on it. So here is an 11 sec combo like the man asked for, But what would my HP at the flywheel have been? Thanks Jason
|
Well I have been told that you loose anywhere between 15%-17% through the drive line. If it was 17% you have
@397FLYWHP. What is your trap RPM with those 4:30's I'm still a little nervous abou that tall of a gear
I have a friend with 347RWHP pulls 11.30's @ 119 NA all motor from a 306, nothing fancy, I hope to be there this spring especially after the diet plan I put my stang on....
------------------
My Ride Check Out My Site 91GT, Holley SysteMAX II Kit-Heads 2.02" x 1.60",Full MAC exhaust 1-5/8" Long tubes, 2-1/2" O.R H-Pipe, 2 1/2" cat back, 12" K&N Filter, RNH PERFORMANCE Ram Air, Ron Davis Radiator, Full Suspension,3:73's, Welds, Best on new motor-12.60 @ 108, no traction 1.98