You definitely have some good choices for different types of headers. The only problem is the labor. Unless you plan to do it yourself, it's going to cost over $800 from start to finish for just a few hp when you are N/A. The book time for shorties is 10 hours and I never looked at what it was for longtubes. I put in a D&D tubular K-member and installed Mac Longtubes in 8 hours which is less than it is to install shorties or longtubes with the stock K-member.
------------------
99 Silver GT
4R70W, ProTorque TC(3200), Transgo, FMS Cooler, Synth. ATF & 3.73 gears
Mac L/T, Cat-H, Borla Cat-back
V2 S-trim, AFR p/p, 70mm t/body, Pro-M80, 42# inj., 255lph pump, JMS chip
D&D K, A-arms, Coil-overs, KB Super Subs, Mac Adj. UCA/LCA, MM C/C Plates
|