Factory studs suck bigtime. I have stripped 4 studs so far just by changing the wheels. I know when I put new ones in, I just pop them thr hole as far as they will go then spin the nut on backwards(cone seat facing out) and tighten nut untill stud pulled in tight. Depending on how much of a shoulder is on the stud sticks past wheel flange you may need a washer. I havnet had to fix any front ones only back, and the backones on my car can suck putting new ones in. The ABS ring makes it tight to get into hole.
As for wheel studs I would use ARP or Moroso.
------------------
2000 GT Laser red-5speed,MAC Cold Air, MAC 2 1/2" Cat-Back, 3.27gears, Pro-5.0 shifter, Weld Draglite's 15x5 and 15x10, 275/50-15 DragT/A's, 165R15 front
Items on car but not run at track yet-BBK offroad X-pipe, BBK Underdrive pullies
Best Quarter mile run to date: 13.50@99.97 (1.87 60')
[This message has been edited by Ares (edited 03-23-2001).]
|