MustangWorks.com : Ford Forums - View Single Post

Ares · 09-12-2001, 05:36 PM

You may want to keep an eye on your rear floor area behind seat where upper control arms mount. I have begun to notice a slight squeek coming from my trunk area since this past sunday. Upon looking I have noticed that my passenger side upper mount has begun to get pulled from floor. The welds are holding but floor is slightly bent out towards the rear end and welds have gone from slighty flush to sunken by over 3/16".

I guess its time to fully weld these mounts in and install battle boxes before I rip something out.

------------------
My '00 GT
2000 GT Laser red-5speed,MAC Cold Air, MAC 2 1/2" Cat-Back, 3.27gears, Pro-5.0 shifter, Weld Draglite's 15x5 and 15x10, 275/50-15 DragT/A's, 165R15 front, BBK Underdrive pullies, BBK offroad X-pipe with Dynomax super converters

Best Quarter mile run to date: 13.296@101.99(9-9-01) Best MPH 102.42(9-9-01)

09-12-2001, 05:36 PM	#1
Ares Registered Member Join Date: Oct 2000 Location: Saxonburg, PA, USA Posts: 236	Cars that launch hard... You may want to keep an eye on your rear floor area behind seat where upper control arms mount. I have begun to notice a slight squeek coming from my trunk area since this past sunday. Upon looking I have noticed that my passenger side upper mount has begun to get pulled from floor. The welds are holding but floor is slightly bent out towards the rear end and welds have gone from slighty flush to sunken by over 3/16". I guess its time to fully weld these mounts in and install battle boxes before I rip something out. ------------------ My '00 GT 2000 GT Laser red-5speed,MAC Cold Air, MAC 2 1/2" Cat-Back, 3.27gears, Pro-5.0 shifter, Weld Draglite's 15x5 and 15x10, 275/50-15 DragT/A's, 165R15 front, BBK Underdrive pullies, BBK offroad X-pipe with Dynomax super converters Best Quarter mile run to date: 13.296@101.99(9-9-01) Best MPH 102.42(9-9-01)