MustangWorks.com : Ford Forums - View Single Post

fiveOsnake · 11-20-2001, 03:58 PM

This coming winter I am looking to install an aftermaket cam into my cobra. The GT40 iron heads are still on the car. I was looking into installing an F-cam. Does anyone run this cam, and will this work well with my heads or is it to aggresive. Will I need new valve springs and rockers or will the current 1.72s work. I'm looking for more upper RPM hp, but cant rev too high stock bottom end with rev limiter still at 6250.

11-20-2001, 03:58 PM	#1
fiveOsnake Registered Member Join Date: Oct 2001 Location: avon lake,ohio usa Posts: 7	FMS cam selection This coming winter I am looking to install an aftermaket cam into my cobra. The GT40 iron heads are still on the car. I was looking into installing an F-cam. Does anyone run this cam, and will this work well with my heads or is it to aggresive. Will I need new valve springs and rockers or will the current 1.72s work. I'm looking for more upper RPM hp, but cant rev too high stock bottom end with rev limiter still at 6250. __________________ 95 Cobra 302 Mods- BBK longtubes,off road h-pipe,flowmasters,underdrives,cold air,75mm maf,70mm t.b. fuel reg,steeda tri-ax, and 4.10s with nittos. Best ET/13.08@104.1