MustangWorks.com : Ford Forums - View Single Post

leo · 03-20-2001, 11:38 AM

I'm installing an explorer upper and a 94 cobra lower and I need some tech advise on this. What do I need to do to make my EGR spacer to fit, there are two threaded ends coming out and two thread inputs for bolts... I need to make sure I have everything since this is my only car I dont want to have it all torn apart and need a part from the stores.

Also, i just got my 3rd gear syncro fixed and now I have this horrible vibration at about 40-45mph and at about 90mph and anything after it gets worse. What did he break... this happended right after I picked it up.. When I'm cruising over 100mph and I push in the clutch the vibration goes away, but only if I'm going over 100...

THanks,
Leo

------------------
1990GT 5.0 302, T-5, 3.73's, K&n Air filter, Dynomax Super Turbo Exhaust, Hypertech Chip, MSD 6A Ignition, RAM Clutch, Motorsport 3 core, Offroad H-pipe.

03-20-2001, 11:38 AM	#1
leo Registered Member Join Date: Oct 1998 Location: Dallas, TX Posts: 261	Explorer intake I'm installing an explorer upper and a 94 cobra lower and I need some tech advise on this. What do I need to do to make my EGR spacer to fit, there are two threaded ends coming out and two thread inputs for bolts... I need to make sure I have everything since this is my only car I dont want to have it all torn apart and need a part from the stores. Also, i just got my 3rd gear syncro fixed and now I have this horrible vibration at about 40-45mph and at about 90mph and anything after it gets worse. What did he break... this happended right after I picked it up.. When I'm cruising over 100mph and I push in the clutch the vibration goes away, but only if I'm going over 100... THanks, Leo ------------------ 1990GT 5.0 302, T-5, 3.73's, K&n Air filter, Dynomax Super Turbo Exhaust, Hypertech Chip, MSD 6A Ignition, RAM Clutch, Motorsport 3 core, Offroad H-pipe.