MustangWorks.com : Ford Forums - View Single Post

95snake · 03-20-2001, 07:38 PM

Does anyone have a email address or phone number for the company? I just did a balance test and it came back with #2 #3 #4 injectors being bad! I was like WTF, I just put those on about 6 months ago and only 1,500-2,000 miles!

I swear, if it isn't one thing, it's another!

------------------
95 Cobra, 9LB Powerdyne, Forged Pistons, Twisted Wedge heads, 70mm TB, Bullet 75mm Mass-air,
TFS 1.7 rockers,
38lb injectors, Roller Timing Chain, Stewart Water Pump, High Flow Oil Pump, B&M Ripper,
SVO HD clutch, 255lph,
Full MSD system w/BTM, MAC Headers,MAC H-pipe w/cats, 3:55's,By-pass valve, Incon Check Valves,Sub-frames, Driveshaft loop, Fuel pressure regulator, flowmasters, A-pillar gauge, intake spacer.

03-20-2001, 07:38 PM	#1
95snake Registered Member Join Date: May 1999 Location: norfolk,va Posts: 265	Lucas Injectors Does anyone have a email address or phone number for the company? I just did a balance test and it came back with #2 #3 #4 injectors being bad! I was like WTF, I just put those on about 6 months ago and only 1,500-2,000 miles! I swear, if it isn't one thing, it's another! ------------------ 95 Cobra, 9LB Powerdyne, Forged Pistons, Twisted Wedge heads, 70mm TB, Bullet 75mm Mass-air, TFS 1.7 rockers, 38lb injectors, Roller Timing Chain, Stewart Water Pump, High Flow Oil Pump, B&M Ripper, SVO HD clutch, 255lph, Full MSD system w/BTM, MAC Headers,MAC H-pipe w/cats, 3:55's,By-pass valve, Incon Check Valves,Sub-frames, Driveshaft loop, Fuel pressure regulator, flowmasters, A-pillar gauge, intake spacer.