I have the Eibach drag launch kit with 70/30s up front and 50/50's in the back. Its cut a 1.604 60' on 26" x 11.5" ET STREETS, with the 4:30's I hope to go sub 1.50.
It doesnt handle that bad, but as stated above don't try to be Mario Andretti.
My car sits level maybe a little lower in the front even, just makes sure the springs are installed right and you won't have any problems, I believe Sky's settled down a bit after his install. I would go 70/30's over the 90/10's unless you plan to have a heavy motor up front, the 90/10's tend to keep the front end up a little higher creating a higher wind drag. If anything mine sits a little lower in the rear on the drivers side depending on how much air is in the spring.
__________________
D/R 10108 NMRA Drag Radial, 25.5 chassis, F1R
Check out RNH Performance Performance Engines and Custom Fabrication. From Mild to Wild we can build what you want, when you want it.
FOR SALE Stainless Steel Torque Box Supports
|