Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-01-2002, 06:59 PM
|
#1 |
|
Registered Member
Join Date: Feb 2002
Location: Concord, CA
Posts: 54
|
Steeda pully install = oil leak?!!
I have recently had Steeda pullies installed in my 97 GT. I have since noticed an oil leak that seems to be centered around from the crankshaft pully. Anyone have this experience, or know the cause, and how to correct it. The oil isn't exactly gushing, but there is a definite loss as there are drips on the ground, and oil on the crank pully and especially on the water pump pully below it...
My mechanic is normally really good, and specializes in performance mods, but I thought that this was a no-brainer install with the correct tools.... I took all the precautions with prepping him, and even supplied Joe Lynch's great instructions to compliment the also provided Steeda ones.
__________________
__________________ '97 GT Convertible, 5-sp. K&N...Tri-ax...Steeda pullies... |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pully install problem | CaliJ1 | Modular Madness | 14 | 07-31-2003 12:34 AM |
| How hard is it to install a Steeda 180 thermostat on the 4.6 mod motor??? | 96_4.6 | Modular Madness | 6 | 12-28-2002 02:05 AM |
| h pipe install, big leak | sn95gt19 | Modular Madness | 0 | 07-21-2002 01:18 AM |
| A Question for 94-95 owners concerning 1.7RR INSTALL | SlowStang2 | Windsor Power | 6 | 09-22-2001 06:39 PM |
| new coolant leak after intake install | fiveohpatrol | Windsor Power | 15 | 03-04-2001 09:15 PM |