oil pickup

302crew · 08-05-2002, 05:14 PM

i just got a morroso 7qt oil pan and i was wonnder will the stock pickup work the pan is only about 2 inches taller than the stock one if that and it has no kick outs on the side and where would i get a pick up for it if its diffrent

mikew88gt · 08-05-2002, 08:20 PM

You will need a new pick-up according to the Moroso section in the PAW catalog. PAW's price is 52.95, p/n MOR-24517 when using the high volume pump if your pan is p/n MOR-20509 which I think it is. Ideally you'd like 1/4-3/8" clearance between the pan and the pickup. Hope this helps.

mikew88gt · 08-05-2002, 08:24 PM

Should have read your original post closer the first time. I thought you had the kicked-out pan which you don't.

In that case use p/n MOR-24506 w/ the high vol pump. It costs 65.95.

08-05-2002, 05:14 PM	#1
302crew Registered Member Join Date: May 1999 Location: sloatsburg Posts: 261	oil pickup i just got a morroso 7qt oil pan and i was wonnder will the stock pickup work the pan is only about 2 inches taller than the stock one if that and it has no kick outs on the side and where would i get a pick up for it if its diffrent __________________ 306 edelbrock 6037 heads full mac exuast 1.7 rr 373 rear hd clutch tremec mighty demon 650 carb msd ignition rpm air gap intake custom cam still trying to get it to run right

08-05-2002, 08:20 PM	#2
mikew88gt Registered Member Join Date: Jul 1999 Location: New York State Posts: 242	You will need a new pick-up according to the Moroso section in the PAW catalog. PAW's price is 52.95, p/n MOR-24517 when using the high volume pump if your pan is p/n MOR-20509 which I think it is. Ideally you'd like 1/4-3/8" clearance between the pan and the pickup. Hope this helps. __________________ Your basic carbed 302 with Edelbrock Performer heads, Performer RPM intake and 650 Speed Demon. My 1988 Mustang GT

08-05-2002, 08:24 PM	#3
mikew88gt Registered Member Join Date: Jul 1999 Location: New York State Posts: 242	Should have read your original post closer the first time. I thought you had the kicked-out pan which you don't. In that case use p/n MOR-24506 w/ the high vol pump. It costs 65.95. __________________ Your basic carbed 302 with Edelbrock Performer heads, Performer RPM intake and 650 Speed Demon. My 1988 Mustang GT

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Need info on leasing a pickup	Mustanguy	Blue Oval Lounge	1	01-30-2003 10:38 AM
EFI or Non EFI tank pickup needed	Coupe Devil	Windsor Power	3	12-04-2002 01:40 PM
Fuel pickup tube	Radon	Windsor Power	1	04-05-2002 10:09 PM
How fast is the Chevy S10 Extreme pickup?	Nitrous Al	Blue Oval Lounge	6	02-18-2002 06:07 PM