Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-07-2002, 06:35 PM
|
#1 |
|
Registered Member
Join Date: Apr 1999
Location: Miami,Fl USA
Posts: 297
|
Qs about Bypass Valve install
I picked up the cheap bypass valve from superchargersonline.com awhile ago for my Powerdyne. I have not intalled it yet because I don't really know what I have to do. I understand the basics of it I just dont know about the tapping or drilling part. Can I just drill it out myself or do I need to have someone tap it with threads? Do I need to glue it or teflon tape it? Do I need to trim the left over threading on the barb that will be sticking inside the pipe? Are the plastic barbs going to take the heat?
Thanks for the help I really want to get that thing in there ASAP Chip
__________________
92 GT Convertible Hooker Headers, Headman X pipe, Flow Masters, 4.10s, BBK 1.5 drop, 73mm Mass air, 65 FMS TB, FMS Aluminum radiator, T-5 swap with a Steeda shifter. And a 9 pound Blow Job |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Bad or Dirty Air Bypass Valve??? | mimicons | Windsor Power | 3 | 11-10-2002 08:02 PM |
| Powerdyne bypass valve install? | FASTFRANK | Windsor Power | 3 | 05-11-2002 12:22 PM |
| throttle air bypass valve | 87 GT MUSTANG | Windsor Power | 1 | 03-27-2002 12:47 PM |
| Air bypass valve ? | Fostang | Windsor Power | 4 | 08-01-2001 02:40 PM |
| Bypass Valve? | Chipdog | Windsor Power | 1 | 07-18-2001 05:56 PM |