Air fliter cover

RPM427 · 08-26-2002, 08:22 AM

It was described on eBay as a PRO M induction tube. It goes over the Long K&N filter. I have been looking for one of these, and possibly trying to make one.

What is the correct name for this? I can't find anyone that sells it. Anyone recocognize it?

PKRWUD · 08-26-2002, 10:33 AM

Looks like a heat shield, but it's hard to tell in that pic.

Take care,
~Chris

RPM427 · 08-26-2002, 10:37 AM

It is a heat shield, I can't find it on pro-m's website, I am not sure if it is made by them.

Does anyone know of a "airbox" or shield that I can buy to fit a 12 inch K&N filter that is similiar to the one pictured?

Will 1/8inch thick sheet styrene melt under the hood? I can mold a cover out of it that will do the same job.

Bad89stang · 08-27-2002, 09:29 AM

It won't melt where you are talking about putting it.

08-26-2002, 10:33 AM	#2
PKRWUD Junior Member Join Date: Mar 1999 Location: Ventura, California Posts: 8,981	Looks like a heat shield, but it's hard to tell in that pic. Take care, ~Chris __________________ Webmaster: Rice Haters Club Jim Porter Racing Peckerwoods Pit Stop Support Your Local RED & WHITE!

08-26-2002, 10:37 AM	#3
RPM427 Registered Member Join Date: Aug 2001 Location: Huntington NY Posts: 573	It is a heat shield, I can't find it on pro-m's website, I am not sure if it is made by them. Does anyone know of a "airbox" or shield that I can buy to fit a 12 inch K&N filter that is similiar to the one pictured? Will 1/8inch thick sheet styrene melt under the hood? I can mold a cover out of it that will do the same job. __________________ -1993 Mustang, 900rwhp 03-04 cobra based 4v swap, full Griggs setup, project underway -1994 Ranger w/ 427cid windsor (daily beater) check it out! Last edited by RPM427; 08-26-2002 at 12:43 PM..

08-27-2002, 09:29 AM	#4
Bad89stang Registered Member Join Date: Aug 2001 Location: Ft. Worth, TX Posts: 456	It won't melt where you are talking about putting it. __________________ You're gonna need your seatbelt

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
New timing cover from Summit	erl2589	Windsor Power	3	06-13-2004 07:28 PM
valve cover to TB hose??	Simi Stang	Windsor Power	11	12-22-2003 02:12 AM
Is a valve cover breather bad for the 4.6????	96_4.6	Modular Madness	6	08-21-2003 06:38 PM
Which valve cover will fit	AWestlx	Windsor Power	6	09-14-2001 04:32 PM
New timing cover dosent fit on 88lx?	Ryan95gt	Windsor Power	3	08-05-2001 10:12 PM