Anderson Motorsports in Illinois

[Smokedawg]

I went to Kenny Brown and asked them about dynoing my car. They told me that I should go to Anderson Motorsports in Clinton Illinois. Has anyone every dealt with these guys before. Its a few hour drive where I am from and I want to make sure its going to be worth my while. I called them and they said $200 for the first hour and 80 for each additional hour and for my car it will prob take about 2 hours. About 2 or 3 pulls a hour. They can measure fuel air mixure. And tune it in.

Is it worth it?

Thanks

------------------
347 Stroker Motor: Balanced, A9P Computer, Cobra Transmission, Extrude Ported and Polished Upper and ported Lower, GT40 Milled Ported and Polished Heads, B303 Cam, BBK 1 5/8 Headers, 30lb Bosch Injectors, Holley Fuel Regulator, March Underdrive Pulleys, Perma-Cool Fan, 3-Core Radiator, Accel Performance Coil, Accel 300+ Racing Wires, Ram Air, K&N Filter, 79mm Mass Air Unit, FlowMaster Exhaust w/BBK Offroad H-Pipe, Hurst Short Throw Shifter, 3:55 Gears, Ram Clutch, Cross Drilled Rotors