Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-24-2002, 08:32 PM
|
#1 |
|
Registered Member
Join Date: Apr 2002
Location: Lakeland, Fl
Posts: 224
|
Porting GT-40P Upper and Lower with a Dremel
Does anyone have any input on porting a GT-40P Upper and Lower with a Dremel? Is there anything I should know before getting into it? I'm new to this so any input would be appriciated. If anything I would like to smooth out the ports for less restricted airflow. But I would like to actually make the ports bigger also. I know this will be a slow process, but it's a learning one at that.
__________________
89 LX Hatch 5.0 5spd, alot of miles, terrible 2.73's, mac cai, pullies, Tri-Ax, 16* timing, elect fan, 3G alt Best to date: 14.331@97.46mph with 14*/stock fan/short belt and a 2.222 60' in 90 degree weather Waiting to put on Off road H and 1 5/8 headers Rice Hater's Club #36 |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| porting upper intake | 93SVTstang | Windsor Power | 1 | 03-13-2002 10:16 AM |
| Upper and Lower intake manifold | I hate Rice | Modular Madness | 5 | 08-30-2001 04:25 PM |
| Explorer upper....but what lower to use??? | 84LX89GT | Windsor Power | 2 | 08-13-2001 05:30 AM |
| REAR UPPER AND LOWER CONTROL ARMS | bcinyuz | Windsor Power | 1 | 05-08-2001 04:17 AM |
| Edelbrock Upper W/ Truck Lower?? | IMPULSERACING | Windsor Power | 2 | 04-16-2001 02:05 PM |