
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#1 |
|
Registered Member
Join Date: Jul 2002
Location: Houston, Texas
Posts: 13
|
I'm rebuilding this '65 200ci motor, and I'm almost done. But there's this, what appears to be a water outlet that I'm not certain about. And it's been a couple of months since I pulled the motor so I don't recall what goes in this hole (go ahead, I can take the jokes).
Anyway, at the front edge of the block, drivers side, behind the lower radiator hose inlet. About a 1" diameter hole, with two bolt holes, and a bracket that attaches to the power steering unit also attaches here. e-mail me directly (stingray@houston.rr.com) if you want a pic of what I'm talking about. I'm stumped, and I don't have any spare parts left over that look like they'd fill the hold, and I certainly don't have any reciprocal water outlets that would accept water from here. As Always......... Wendell |
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Possible oil in water?? | Simi Stang | Windsor Power | 1 | 01-24-2003 02:55 PM |
| P/S bracket and hose | mike34cpe | Classic Mustangs | 0 | 11-04-2002 08:58 PM |
| Free Horsepower, but at what cost?? | 71grande | Classic Mustangs | 13 | 09-21-2002 05:07 PM |
| Water pump....AC Bracket problem | Jimmy Page | Classic Mustangs | 3 | 07-28-2001 01:54 PM |
| Pulleys, water pump, and fan clutch | dinomite | Windsor Power | 5 | 05-26-2001 09:00 AM |
