Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-09-2003, 10:35 AM
|
#1 |
|
Registered Member
Join Date: Apr 2001
Location: Hampton, Virginia
Posts: 227
|
Welding ?
The bolt holes on the right side of my block are broken. The metal has actually seperated , so I am going to weld in two threaded rods and I want the stongest weld as possible. I have the option of using a 80 amp flex core wire welder or a 70 amp arc welder. Which would provide the strongest weld? The two bolt holes I am refering to are the ones that sit over the water passage.
__________________
1980 RX7 with 289 Ford V-8 bored .030 over, Very radical cam, Torker 2 high rise intake, Holley 650 Carb, MSD Nascar 6ALN ignition, MSD coil and distributor, Headers with dual open side exhaust. Over 300 horse. 1966 Mustang still in progress |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Welding torque boxes...tips? | Coupe50h | Windsor Power | 8 | 03-07-2003 11:55 PM |
| Questions on Roll Cages, Welding, and Ignition | BlackFireN2O | Windsor Power | 3 | 08-25-2002 08:01 AM |
| welding SF connectors | RPM427 | Windsor Power | 5 | 07-01-2002 02:48 PM |
| Welding in subframes and removing front sway bar . What should I run?? | Dark_5.0 | Windsor Power | 4 | 10-27-2001 03:06 AM |
| welding torque boxes. what do you actully weld? | Brian88 | Windsor Power | 1 | 09-03-2001 09:56 PM |