Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-17-2003, 10:50 PM
|
#1 |
|
Registered Member
Join Date: Jan 2003
Location: Palm Bay, FL
Posts: 432
|
IAC Disconnect?
I've heard from several people that disconnecting the IAC valve on an EFI 5.0 will give it a really quick, carb-like rev. First off, is this accurate? I had the engine off and disconnected the sensor clip to the IAC, started it....nothing was different. Still revved normal. Am I missing something? And as a side note...are there any negative effects to disabling the IAC valve, besides a funny idle and an occasional stall here and there maybe?
__________________
'91 Mustang GT 5.0 AOD Daily Driver Current stats: NEW 302 short block, E-303 cam (@.050, 220/220, .498/.498, 110 degrees), 1.6 roller rockers, Performer RPM heads (aluminum, 1.9/1.6, 60cc chambers), Cobra intake, Granatelli 75mm MAF, Billet AFPR, Equal-Length Shorty Headers, Off-Road X Pipe, Flowmasters, 4.10 POSI 13.73 at 103.8, ~2.2 60' |
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| What happens if i disconnect this?! | 90LxDroptop | Windsor Power | 5 | 10-10-2003 12:01 PM |
| Battery Disconnect and ECM Reset | mimicons | Windsor Power | 1 | 02-18-2003 11:20 AM |
| How to disconnect the fuel lines? | Deividas93GT | Windsor Power | 3 | 12-03-2002 09:00 AM |
| Battery Disconnect Install Question? | Sparkplug | Windsor Power | 7 | 07-29-2001 12:29 AM |
| Battery disconnect switch with stator wir disconnect | 2FastLX | Blue Oval Lounge | 0 | 04-07-2001 08:15 PM |