Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-20-2006, 03:27 PM
|
#1 |
|
Moon Equepted
Join Date: Jul 2006
Location: Sucker Free City (San Francisco)
Posts: 17
|
What the F
Why on earth wont the distributor go in? There's a small rod at the bottom of the hole that I'm guessing fits into the shaft of the distributor. Well said rod is leaning against the side of the opening and wont slip in. I thought if I raised the back of the car it would allow the rod to fall forward a bit but no luck. I'm stumped. Any tricks? Can I grease up the end of the distributor shaft? What exactly is that rod and where does it go/what does it do? Can I get to it from the bottom? Man I wish I had a real shop manual and a parts book. My chilton book really isn't helping much.
Help me Obi Won Kenobi, you're my only hope. MoonStang |
|
|
|
|