
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
|
#1 |
|
Guest
Posts: n/a
|
Any ideas???
pulled the carb, and replaced the power valve.. still backfired through the carb, turned the mixture screws out and it decreased a bit (must of been lean).. but it still does it, not as bad but still there!! almost there.... could it be the outside temp and the jetting????? coil prob was a disconnected wire!! thx Chris for your help!!! ------------------ 84 GT,shorty headers, open dual's, bored .060, 10.5" clutch, T5, 89 heads, edelbrock Performer manifold, matched cam, 600 Holley.. |
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Should I Run a Carb or EFI Setup? Please Help | BlackFireN2O | Windsor Power | 1 | 08-07-2002 03:16 PM |
| to carb, or not to carb...this is my question. | black86notch | Windsor Power | 4 | 08-06-2002 08:24 PM |
| Carb Woahs | RoadWarrior | Classic Mustangs | 4 | 07-27-2002 11:06 AM |
| efi to carb. /? | WADS56 | Windsor Power | 0 | 09-26-2001 12:45 AM |
| new carb..but how much cfm?? | 69PonyRider | Classic Mustangs | 4 | 09-13-2001 07:59 AM |
