Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-08-2001, 10:59 PM
|
#1 |
|
Registered Member
Join Date: Dec 2000
Location: Laguna Niguel Ca
Posts: 46
|
Oops I cracked a head
I have a 66 289. The stock head on the driver side has two cracks near the 1st two bolts. They appear to only leak to the outside of the head but it is possible a little coolant is getting into the combustion chambers. Any body have suggestions on where to look for new heads? I am looking for only modest performance gains over stock heads at a minimal cost. I have considered bidding on a set of heads through ebay but I wanted to get your input first.
|
|
|
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Could a head gasket cause a tapping? | Michael Smith | Windsor Power | 13 | 09-27-2004 07:10 PM |
| head light problem | crazyi | Windsor Power | 5 | 12-17-2003 06:37 PM |
| DOHC 4.6L head | mynameisjohn | Modular Madness | 4 | 04-25-2003 05:05 PM |
| what head ? | faststang90 | Windsor Power | 3 | 09-08-2002 07:17 PM |
| Anyone ever used the ultra seal 5751 silicor head gaskets yet? | 11secondGT | Windsor Power | 0 | 08-06-2002 10:23 PM |