![SEARCH](http://www.mustangworks.com/images/search.png)
![The Mustang Works](http://www.mustangworks.com/images/mw_footer_logo.gif)
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
|
![]() |
#1 |
Registered Member
Join Date: Feb 1999
Location: berkley mass
Posts: 98
|
![]() I unbolted everything and still no clearence.I unbolted the motor mounts,but they only dropped 1inch.should I try too pry it down.this is my 1st time and have no idea on front wheel drive.someone help! ------------------ 90 lx conv.357 e-mail louie-22@webtv.net homepage http://www.geocities.com/motorcity/factory/5577 |
![]() |
![]() |
![]() |
#2 |
Registered Member
Join Date: May 1999
Location: Ramsey, MN - USA
Posts: 52
|
![]() You need to remove the entire cradle and support the engine from the top with some kind of beams across the fenders and one across the firewall and the radiator support. Then remove the trans. You'll never get it out any other way. Keep all motor mounts attached except the ones that are hooked to the cradle. You'll need to pull the axles as well. It's a big job, and a hoist would help a ton.
Before you remove the cradle, you need to mark it so it is back in exactly the same spot, or it will throw the alignment off. Might be a good idea to have it aligned afterwards anyway. |
![]() |
![]() |
![]() |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Yet another tranny fluid ?? | Simi Stang | Windsor Power | 4 | 09-30-2003 12:44 PM |
Tranny update...Lentech VB | silver_pilate | Blue Oval Lounge | 10 | 05-02-2002 12:34 PM |
Tranny probs | sleeperstang | Classic Mustangs | 2 | 10-21-2001 11:38 AM |
This is bad! Did my Uncle cause my Racing tranny to overheat?(It's a long 1... sorry) | Stang_ROTY | Windsor Power | 1 | 08-30-2001 10:55 PM |
aod tranny pan removal | sockmonkey | Windsor Power | 0 | 06-06-2001 05:22 PM |