351C 4V heads

jackw · 06-20-1999, 09:03 PM

Where can I get a dual quad, low or medium rise manifold for this engine. I have tried Offenhauser, Edelbrock etc. Any info would be greatly appreciated

MEDIK418 · 06-22-1999, 04:27 AM

The only dual anything manifold I've seen for the Cleveland is a 9 inch tunnel ram somewhere in a Summit catalog.

jackw · 06-22-1999, 09:58 PM

I like to have some HP under the hood without cutting it. Thanks for the info

MEDIK418 · 06-23-1999, 02:38 AM

I'm pulling about 330 horses out of our Cleveland with a 600 Holley on a factory manifold. Ours is basically stock but I know a feller here in Amarillo who's pulling in the neighborhood of 650 horses at 8500rpm with a single 900 holley.

------------------
Father to two Teenage boys and three Mustangs. 71 Mach 1, 85 LX trunk, and one '89 GT
Someday. . . It's gonna be Dad's turn to build one.

06-20-1999, 09:03 PM	#1
jackw Registered Member Join Date: Jun 1999 Location: Norton, MA USA Posts: 5	351C 4V heads Where can I get a dual quad, low or medium rise manifold for this engine. I have tried Offenhauser, Edelbrock etc. Any info would be greatly appreciated

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GT-40 heads	5.0 Pony	Windsor Power	1	09-10-2002 10:26 PM
val springs in stock 97 heads , quesion ?	southernstang97	Modular Madness	0	07-16-2002 11:52 AM
Help with heads, what to do????	HiFlow5 0	Windsor Power	5	07-14-2002 06:22 AM
My NEW replacement Holley heads are different!	Rick 91GT	Windsor Power	8	04-23-2001 06:45 AM
Which heads are beter?	patman	Classic Mustangs	3	12-02-1999 03:42 AM

06-22-1999, 04:27 AM	#2
MEDIK418 Registered Member Join Date: Mar 1999 Location: Amarillo, Texas, USA Posts: 780	The only dual anything manifold I've seen for the Cleveland is a 9 inch tunnel ram somewhere in a Summit catalog.

06-22-1999, 09:58 PM	#3
jackw Registered Member Join Date: Jun 1999 Location: Norton, MA USA Posts: 5	I like to have some HP under the hood without cutting it. Thanks for the info

06-23-1999, 02:38 AM	#4
MEDIK418 Registered Member Join Date: Mar 1999 Location: Amarillo, Texas, USA Posts: 780	I'm pulling about 330 horses out of our Cleveland with a 600 Holley on a factory manifold. Ours is basically stock but I know a feller here in Amarillo who's pulling in the neighborhood of 650 horses at 8500rpm with a single 900 holley. ------------------ Father to two Teenage boys and three Mustangs. 71 Mach 1, 85 LX trunk, and one '89 GT Someday. . . It's gonna be Dad's turn to build one.