Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
02-27-2003, 05:57 PM
|
#1 |
|
Registered Member
Join Date: Feb 2003
Location: roseville mi.
Posts: 26
|
1.7 roller rockers
I'm just wanted to know if any one else has used 1.7 rockers on a non mass air car and if this will effect my cars performance.
86 mustang Current mods new short block with valve releif gt40p heads gt40 intake 1 5/8 headers full 2.5 inch exhaust stock cam(ran out of money) Thanks for any help |
|
|
|
02-27-2003, 06:29 PM
|
#2 |
|
Registered Member
Join Date: Dec 2002
Location: Columbus, OH
Posts: 100
|
1.7's would work fine.
Murdock |
|
|
|
|
02-28-2003, 07:03 PM
|
#3 |
|
Registered Member
Join Date: Sep 2000
Location: southern california
Posts: 329
|
30,000miles later on mine still going
__________________
1987 black with t-tops. Cobra intake, 1.7 cobra crane rollers, gt40p's, bbk shorties, off road h-pipe, Holley adj. fuel pressure regulator, Tremec t-5z, 65mm TB, 4.10's, adj cable, 155lph fuel pump, Ram clutch kit, 3 row motorsport radiator, Chrome cobras17x9 front, 17x10.5 rear, Hurst shifter,Former AOD Semper Fi |
|
|
|
|
03-01-2003, 09:25 PM
|
#4 |
|
Registered Member
Join Date: Jan 2002
Location: Mt. Prospect,IL
Posts: 474
|
you can do it i am pulling off everything in my sig and i have a small idle surge but that is because of the 70mm tb
later
__________________
87-ford-mustang-SOLD! mods: 3:73's, off road h-pipe, b303 cam in gt- 40 motor w/ Power Plus intake, edelbrock 70mm tb & egr spacer, 72mm C&L, bbk long tubes, tremec tranny, centerforce dual friction clutch, upr and lwr CA's 255lph FP and soon more to come.... when i have money again SOME ADVICE Don't do burn outs in reverse it is very expensive New times with dead hook on dr's 13.27@103 with 2.0 60 foots w/100lb system Fastest time to date: 12.8@113 |
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Roller rockers for stock heads | QuantumMotorsports | Windsor Power | 1 | 07-14-2003 03:15 PM |
| Roller Rockers, bad? | HiFlow5 0 | Windsor Power | 1 | 04-14-2002 01:35 PM |
| roller rockers | bobtodd | Windsor Power | 4 | 04-07-2002 01:34 PM |
| reg rockers or roller rockers?? | Chevysucks | Windsor Power | 1 | 12-05-2001 08:17 PM |
| Valve Springs & Roller Rockers | StreetStang37 | Windsor Power | 4 | 04-17-2001 03:54 AM |