Linear Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-24-2001, 09:37 AM
|
#1 |
|
Registered Member
Join Date: Feb 2001
Location: Delray Beach, Florida
Posts: 97
|
High Grade Bolts
Loews carries a selection of automotive high grade bolts and fasteners. Do you think it's ok to use these for some suspension bolt replacement?
|
|
|
|
07-24-2001, 10:13 AM
|
#2 |
|
The Dude
Join Date: Feb 2001
Location: Arlington, VA
Posts: 1,262
|
suspension bolts are "grade 8", if you have any question as to whether the ones a loews will cut it, don't use em! i had a helluva time finding replacement bolts when i redid my rear susp., your best bet is to be careful as you disassemble, so that they can stay in good shape. your local ford dealer *might* have the bolts you want.
|
|
|
|
|
07-24-2001, 10:51 AM
|
#3 |
|
Registered Member
Join Date: Oct 1998
Location: Rogers, MN
Posts: 2,089
|
Suspension bolts are metric. Mine were 9.6 and 10.8. I replaced them all with stainless steel 10.8s from a hardware store. My stock bolts were shot.
------------------ 351W 89 Mustang GT Convertible |
|
|
|
|
07-25-2001, 12:30 AM
|
#4 |
|
Registered Member
Join Date: Jan 2000
Location: Concord,CA
Posts: 86
|
Stainless steel bolts are not as strong as grade 8's. I would not use them in any critical places like suspension ect...
------------------ |
|
|
|
|
07-25-2001, 01:59 AM
|
#5 |
|
Registered Member
Join Date: Oct 1998
Location: Rogers, MN
Posts: 2,089
|
A graded bolt is a graded bolt. The 10.8s I used are stronger than the 9.6 that were on there and they happen to be stainless steel.
------------------ 351W 89 Mustang GT Convertible |
|
|
|
 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| Only 3 bolts holding fan to water pump? | Hethj7 | Windsor Power | 5 | 03-27-2003 03:26 PM |
| Pressure plate bolts | WhiteLX | Windsor Power | 1 | 09-15-2002 06:50 AM |
| WTF? Ring gear bolts came loose and went threw Diff cover! | 93CobraR | Windsor Power | 6 | 11-07-2001 07:23 PM |