Air Pump Idler

Toeclicker · 11-18-2003, 12:12 AM

Just wondering if there were any drawbacks to getting an air pump idler...

GhOsT6_9 · 11-18-2003, 06:06 PM

No draw backs other then not being able to pass an emissions test. And if you have any cats that need the air pump you'll burn them out by removing it.

QuantumMotorsports · 11-18-2003, 07:56 PM

Why get an idler when you can get a short belt. Cheaper, does the same thing. Go to www.fordmuscle.com they've got a tech article on how to route the shorter belt without the air pump.

11-18-2003, 12:12 AM	#1
Toeclicker Registered Member Join Date: Mar 2003 Location: florida Posts: 24	Air Pump Idler Just wondering if there were any drawbacks to getting an air pump idler... __________________ 93 LX 5.0 swapped to 347 turbo

11-18-2003, 06:06 PM	#2
GhOsT6_9 Registered Member Join Date: May 2000 Location: Ontario,Canada Posts: 233	No draw backs other then not being able to pass an emissions test. And if you have any cats that need the air pump you'll burn them out by removing it. __________________ 1989 Mustang LX Notch 5.0L, T-5, 1969 351W heads, cut & welded stock plenum, F-303 cam, Mac 1 5/8 full length headers, Cat'd H-pipe, 3.73 gears, Underdrives, SSM lift bars, E-Fan, 3G Alt, Custom Chip, Autometer gauges, Weld Draglite wheels , M/T ET Street Radials Best 1/4: 13.33@101.53MPH

11-18-2003, 07:56 PM	#3
QuantumMotorsports Registered Member Join Date: Jul 2000 Location: Norman, Oklahoma, USA Posts: 597	Why get an idler when you can get a short belt. Cheaper, does the same thing. Go to www.fordmuscle.com they've got a tech article on how to route the shorter belt without the air pump. __________________ Michael Black QuantumMotorsports Norman, OK 1984 LX Hatch 306 w/ TRW forged flat toppers, Comp Cams Magnum 292H, GT40P heads w/ 3 angle valve job, .550 lift springs, Angus Racing Roller Rockers, Weiand Stealth Intake, Holley 4150 650cfm carb, MAC 1 5/8 Long Tubes, Single Chamber Flowmasters, 91' T5 w/ Pro 5.0 shifter, Turbo Coupe 8.8 Rear w/ 3.55 gears, QA1 Motorsports tubular K member, no interior except steering wheel and seat. Coming soon: 6 or 8 point cage, Fuel Cell, Weld Draglites

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Confused, I need help on different fuel pump wiring methods.	5.0 Fiend	Windsor Power	12	10-14-2004 06:43 PM
oil pump installation question	82 GT	Windsor Power	3	07-03-2003 02:03 PM
Fuel pump relay questions	Big Bopper	Windsor Power	1	11-10-2002 10:20 PM
STEWART Water Pump issues :( ??	LOBE_50	Windsor Power	6	05-15-2002 08:34 AM
Lost another oil pump	oldman	Windsor Power	2	10-20-2001 11:14 AM