Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-22-2001, 11:34 PM
|
#2 |
|
Guest
Posts: n/a
|
the green wire coming off the negative side of the coil is your tach output.. DO NOT SPLICE THIS WIRE add with BUTT CONNECTORS the splice will cause a short and stall the car out sometime in the future.
------------------ SOLD THE 87GT, .. GT40, 70mmTB, 75mmBullet, 24lbinjectors, cold air induction, Edelbrok 6025 Rpm's, Inch phonolic spacer, tall FMSvalve covers, an SFI balancer, Canton 7quart, the shortblock... Lunati 51025 (224/232 .535/. 544 @112 deg) Ross lightweight pistons (10:1) Eagle H-Beams, Total Seal plasma Moly Rings, Clevite bearings, ARP throughout, FMS main Girdle&Studs, Forged Crank, of course HV-OilPump and hardened FMS shaft, Dual Friction centerforce, T5, and 4.10's Longtubes and 2.25 tail pi |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| HEGO orange wire grounds to manifold?? | Simi Stang | Windsor Power | 2 | 12-19-2003 08:13 AM |
| again, How to cure code 66 (maf below minimum voltage) ???? | HAITHAM | Windsor Power | 6 | 11-12-2001 09:10 AM |
| Need some on wire palcement for 5" tach with shift ligh..... | Coolbreeze | Windsor Power | 3 | 10-07-2001 06:51 PM |
| AOD Shift 1st, 3rd, 4th...Hello... 2nd?!? | jz_mustang50 | Blue Oval Lounge | 2 | 09-18-2001 11:30 PM |
| anyone shift higher on 3-4 shift? | fiveohpatrol | Windsor Power | 4 | 09-16-2001 08:39 PM |