Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-29-2001, 01:26 PM
|
#2 |
|
Registered Member
Join Date: Jun 1999
Location: North Haven,CT
Posts: 336
|
The cam might be a little too steep for SD, but there are a lot of guys running a lot heavier set ups without mass air.
Give it a shot, the worst that will happen is it will run like crap and a conversion will be necessary, but the mass air would be good to do anyway. ------------------ 1992 LX:V-1 S-Trim ,Edelbrock 6037 Heads,Cobra Intake,E-303,1.6 Rollers,65MM Holley TB, 75 MM Pro M Mass Air, 190 LPH FP,24 lb injectors,MSD 6A and BTM,BBK equal length shorties,offroad h-pipe,Mac Flowpath Mufflers,Pro 5.0, 3.73's,Motorsport "C" springs,welded subframe connectors,Ponies w/ 225/50 Nitto NT 450's on front,255/50 BFG Drags out back,93 Cobra Spoiler Daily driver 89 Coupe:BBK shorties,offroad,flowturds with dumps,soon to be cyber green |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Speed Density Cobra? | UglyFast88 | Windsor Power | 6 | 12-10-2002 11:25 PM |
| First ticket. Sucks, sucks bad. | zepherman | Blue Oval Lounge | 46 | 12-16-2001 07:24 PM |
| EFI conversion with Speed Density and a 351w? | PSI GUY | Windsor Power | 2 | 12-02-2001 11:13 PM |
| Holley systemax 1 on speed density | Yan88gt | Windsor Power | 1 | 06-17-2001 08:51 PM |
| speed density question.. | bobtodd | Blue Oval Lounge | 2 | 04-15-2001 02:03 AM |