Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
03-07-2002, 01:30 AM
|
#1 |
|
Registered Member
Join Date: Mar 2002
Location: Midwest
Posts: 1
|
1.7 Rockers?
What's up everyone, new member here. I'm currently running ProForm 1.6 rr's, and an E-303 cam. My questions are can I run 1.7 rr's with the E-cam without having interference problems, and will I gain anything if I do this swap? I did not degree the cam, just put it in straight up. I've been told that this can be done by several different people. Now the problem is the more research I do, the more different awswers I get. Any help would be appreciated. Thanks in advance.
__________________
'90 Notch 302 .030' over with DSS 306 internals. Edelbrock Heads, E-303, 1.6 RR's, Cobra Intake, 65 mm TB, 3:73's, Mac headers, Mac Cat-back, off road h-pipe. 13.25 at 104 mph. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Dont use 1.7 rockers with stock heads? | Coupe5oh | Windsor Power | 10 | 11-28-2015 12:36 PM |
| Noise rockers Help?????? | 393Clevor | Windsor Power | 5 | 07-21-2003 06:44 AM |
| Rail Rockers on 289 Small Block Heads | sleeperstang | Classic Mustangs | 16 | 05-11-2003 11:34 PM |
| Roller Rockers, bad? | HiFlow5 0 | Windsor Power | 1 | 04-14-2002 01:35 PM |
| reg rockers or roller rockers?? | Chevysucks | Windsor Power | 1 | 12-05-2001 08:17 PM |