WHO MAKES THE BEST MASS AIR METERS

2FastLX · 04-23-2001, 10:02 AM

I have the C&L 76mm meter and my engine kinda bucks at part throttle too when I am in too high of a gear. As long as my RPM is up above 1500rpm it is fine. But I was thinking that was my tranny because it is toast. Is that what yours is doing? Mine has a bit of a surging idle problem but other than that the engine runs fine when it's in neutral. I can push the throttle down slightly (where it normally bucks while driving) and it runs fine. It's just when I am driving it and cruising at low rpms it wants to buck. I put all my current mods on at the same time so I really have no idea what is causing this (if it isn't my tranny). I am getting a new tranny installed this week so i'll see then if the tranny was the culprit.

I guess now I can't really say if the C&L 76mm is the best which is what I was coming here to do =P If it still does this after the tranny is installed I'll try swapping a meter with a friend and see if that helps.

It may just be my new setup not wanting to run at those low RPMs because I used to shift into 5th at 45mph with no problems whatsoever. Now it seems I have to shift to 5th at 55mph.
------------------
ICQ# 42269241
Indiana Stangers Association
Buy your parts here

[This message has been edited by 2FastLX (edited 04-23-2001).]

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Good Prices on Mass Air Meters	ChunkFunky	Windsor Power	9	03-04-2003 01:56 PM
Mass Air Meters with Cold Air on 2003GT	micool	Modular Madness	2	02-19-2003 09:41 PM
Bottom Line With Mass Air Meters	gtsr515	Windsor Power	13	04-27-2002 01:40 PM
Group Purchase-Mass Air Meters	BlackSunshine	Racer's Club House	0	11-24-2000 02:00 PM
Group Purchase-Mass Air Meters	BlackSunshine	Modular Madness	0	11-24-2000 01:57 PM

04-23-2001, 10:02 AM	#6
2FastLX The Photoshop Guru Join Date: Feb 2001 Location: Mecca, Indiana Posts: 1,419	I have the C&L 76mm meter and my engine kinda bucks at part throttle too when I am in too high of a gear. As long as my RPM is up above 1500rpm it is fine. But I was thinking that was my tranny because it is toast. Is that what yours is doing? Mine has a bit of a surging idle problem but other than that the engine runs fine when it's in neutral. I can push the throttle down slightly (where it normally bucks while driving) and it runs fine. It's just when I am driving it and cruising at low rpms it wants to buck. I put all my current mods on at the same time so I really have no idea what is causing this (if it isn't my tranny). I am getting a new tranny installed this week so i'll see then if the tranny was the culprit. I guess now I can't really say if the C&L 76mm is the best which is what I was coming here to do =P If it still does this after the tranny is installed I'll try swapping a meter with a friend and see if that helps. It may just be my new setup not wanting to run at those low RPMs because I used to shift into 5th at 45mph with no problems whatsoever. Now it seems I have to shift to 5th at 55mph. ------------------ ICQ# 42269241 Indiana Stangers Association Buy your parts here [This message has been edited by 2FastLX (edited 04-23-2001).]