does gt40 intake work with sn95?

Daves94vert · 01-13-2001, 03:20 AM

What I did was to leave the intake and heads for one of my last mods b/c although you will see gains with them, you will gain much more with a good supporting team of parts. for example; get a set of 3.55 or 3.73 gears, throttle body, 75mm pro-m bullit mass air sensor, pulleys, full exhaust(from the headers back), a good shifter like a pro 5.0 shifter or steeda tri-ax ...,fuel pressure regulator and a fuel pressure guage to monitor and fine tune your fuel pressure. Then,I would add the intake and heads to see a huge gain in performance. With the addition of heads and intake with stock parts is useless without a good supporting cast. Sure it will take longer to do it this way but the gains per part(heads and intake)will be much more dramatic. At least that's what I did. By the way, save for a set of good tires b/c you'll need them for traction. In between performance parts, get some rear upper and lower control arms. What I did to select performance parts was to buy a notebook and write down my "wishlist" of parts and put them in categories like suspension/engine/drivetrain...and work from there. But I have to warn you, once you start you'll never stop. Later.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
GT40 vs Stock lower intake difference	ca_mustang	Windsor Power	3	03-02-2004 05:03 PM
351W GT40 Lower intake needed..	mardyn	Windsor Power	0	01-15-2004 07:03 PM
GT40 intake good enough?	91evilstang	Windsor Power	8	09-02-2001 04:41 PM
SN95 MAC Intake Elbow	fastang	Windsor Power	2	08-04-2001 11:33 PM
Need some professional advice - head work, valve springs, rockers, cam. pretty long.	AxemanZZ	Windsor Power	15	01-11-2001 01:30 PM

01-13-2001, 03:20 AM	#8
Daves94vert Registered Member Join Date: Apr 2000 Posts: 10	What I did was to leave the intake and heads for one of my last mods b/c although you will see gains with them, you will gain much more with a good supporting team of parts. for example; get a set of 3.55 or 3.73 gears, throttle body, 75mm pro-m bullit mass air sensor, pulleys, full exhaust(from the headers back), a good shifter like a pro 5.0 shifter or steeda tri-ax ...,fuel pressure regulator and a fuel pressure guage to monitor and fine tune your fuel pressure. Then,I would add the intake and heads to see a huge gain in performance. With the addition of heads and intake with stock parts is useless without a good supporting cast. Sure it will take longer to do it this way but the gains per part(heads and intake)will be much more dramatic. At least that's what I did. By the way, save for a set of good tires b/c you'll need them for traction. In between performance parts, get some rear upper and lower control arms. What I did to select performance parts was to buy a notebook and write down my "wishlist" of parts and put them in categories like suspension/engine/drivetrain...and work from there. But I have to warn you, once you start you'll never stop. Later.