Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
04-20-2002, 03:35 PM
|
#2 |
|
Registered Member
Join Date: Jan 1999
Location: Las Vegas NV
Posts: 286
|
Shut up and drive joe. J/K
Need a little more info but from what you are saying about problems feathering the clutch up an inclne it sounds like it might be just your clutch. If your clutch cable set up is still factory try and pull up on the clutch pedal and then pressing it all the way to the floor. You should hear a ratcheting sound from the quadrant adjusting this might help you out a little. Try that and let us know how long it has been since the clutch was replaced. Do the gears grind when you try and put it in gear? |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Loud "pop" after clutch install, won't go into gear.. | Chris_H | Windsor Power | 3 | 08-11-2003 06:24 PM |
| T-5 swap & cable clutch problem | LuvMyStang | Classic Mustangs | 0 | 03-19-2003 08:47 AM |
| '65 Mustang - Pull Away Problems | geordie | Classic Mustangs | 6 | 05-11-2002 04:46 PM |
| Clutch Problems | blue302 | Windsor Power | 3 | 09-10-2001 01:37 PM |
| billed 5 times to install clutch by Pauls Auto, please read and give opinions (long) | beefcake | Blue Oval Lounge | 2 | 02-23-2001 03:05 PM |