Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-06-2002, 11:58 AM
|
#1 |
|
Registered Member
Join Date: Jun 1999
Location: Walker, MI, USA
Posts: 1,202
|
Still Am a high Idle......
I still seem to have a Some what high Idle Like 1400-1200Rpms I am 100% sure that there is No Vac Leak At all.......will Idle good for like 10 min. or so Tell the car get good And Warm.... I am running a 160 temp Stat could that be doing it I have new sensors and evey thing I dont get it........it is where I can bare it But would be nice to fix it.... Any One have any Ideas????? I will try to put a Diff IAC I have a new one.. and a old One But the old one was good.........
__________________
Engine: steel mounts, Under drive pulleys, K&N, GT-40 Intake ported Lower, No power steering, No A/C, Mac cold intake, 65MM TB, 255 Fuel pump, 24's, AFR 165 58cc, Rocker Arms 1.7with the stock Cam, 1 5/8 short headers, offRoad X-pipe Drive Train: 3.55, T-5 with a Pro 5.0 shifter 12.656@107.71MPH See It at www.T-racing.com/mustang.htm |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| High idle | Hethj7 | Windsor Power | 7 | 08-04-2004 05:45 PM |
| Adjusting Length of high idle on Carb 5.0 | twilightcall | Windsor Power | 8 | 08-06-2003 08:31 AM |
| Low, loppy idle then too high, then low again.... | Fox Body | Windsor Power | 6 | 08-05-2003 11:29 PM |
| Idle too high, Popping thru intake still . . . | SheStang87 | Windsor Power | 3 | 06-23-2003 10:32 PM |
| Idle too high after TB install... | Bad89stang | Windsor Power | 18 | 04-24-2002 09:41 PM |