Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-30-2002, 03:23 PM
|
#9 |
|
Registered Member
Join Date: Apr 2000
Location: middleburg, fl, usa
Posts: 1,134
|
Actually I read in 5.0 magazine a couple of years ago that they tested and extrude honed and retested several intakes and they found that the extrude honed stock intake out flowed the non extrude honed cobra intake and had a better runner balance of all the intakes tested.
After the extrude honed the cobra intake it did flow more than the stock one but they did say they could have even removed more material if they wanted. They also said that the stock extrude honed intake was a very good intake. I will agree that you can do better than the stock intake but if you are going for the stock look or do not have the money for the extrude honed or after market intake and know how to hand port it that it will work good if done right.
__________________
James Cox RHC Member #44 nochevy@hotmail.com 1991 Mustang LX Dart iron eagle block, 4340 28oz 347 crank, 4340 h-beam rods, probe ultra light pistons canfield heads “race ported by Brent Frazier”, solid roller cam and lifters “custom grind”, kooks 1 7/8" race headers, and much more. Engine built by Brent Frazier. |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Extrude hone intake | erl2589 | Windsor Power | 4 | 11-12-2003 03:43 PM |
| Extrude Hone Question | AntwaanRandleEL | Windsor Power | 4 | 03-20-2003 12:19 AM |
| Extrude Hone | Doctor DeBo | Windsor Power | 2 | 03-09-2001 09:33 PM |
| Extrude hone question | 84stang83zephyr | Windsor Power | 1 | 03-02-2001 08:07 PM |
| best price for extrude hone | 88workcar | Windsor Power | 3 | 01-15-2001 05:49 AM |