Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
06-25-2002, 09:32 PM
|
#3 |
|
Registered Member
Join Date: May 2002
Location: Tampa,FLORIDA
Posts: 340
|
well, i have not really thought about the fuel system yet, but in the past i just used the mechanical pump. Do I need electric?
I was thinking about the #2 tfs cam also, so its good to hear feed back on it. Should I go with the TFS forged pistons that are supposed to match the heads($500), or the TRW forged($250). Also, the block is not currently a roller motor, I am going to convert it. Should be ok? Anything i need to do to prep it for future nitrous upgrade, like wire lock heads? So how much horsepower should be available with all this, any ideas?
__________________
5.0, Holley heads, 1.7 Scorp Rockers, Stealth intake, Holley 600 carb, Holley Mech. Fuel pump, MSD 6Digital, MSD distributor, Hotchkis upper/lower rear control arms, FMS B Springs, 3:73 (8.8) rear. Production # 9,377 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| rebuild or not to rebuild??? | NotchStang59311 | Windsor Power | 9 | 04-14-2004 05:28 PM |
| T-5 Rebuild | 95/GT/5.0 | Windsor Power | 9 | 12-26-2002 10:23 PM |
| TRANS rebuild kits for 5spd | drtbiker | Windsor Power | 3 | 08-18-2002 04:25 PM |
| Low cost rebuild. | salcmc | Classic Mustangs | 3 | 09-11-2001 09:16 PM |
| 99 GT, auto tranny rebuild | red99stang | Modular Madness | 5 | 05-22-2000 03:37 AM |