Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
08-13-2002, 11:48 AM
|
#4 |
|
Registered Member
Join Date: Jun 2002
Location: Western,MA
Posts: 254
|
you can not do it without the right tools i`ve done them before you would need a dial indicator to check backlash some form of plastigauge or yellow gease to check gear engagement and a good torque wrench,an impact gun, and about 6 or more hours i`ve done it before my first time took me 9 hours to get it right, and that was with the help of a proffessional mechanic and use of a shop. pay to have it done if it`s done wrong it will cost you more than 250.00 for a new axle and gears and carrier.
__________________
Rice Haters Club Member #55 For My car Specs Click the Home page link http://www.badassyellowgt.50g.com/ |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| ring and pinion gear installation | chiaronate | Windsor Power | 5 | 11-05-2002 07:47 PM |
| Help Quick Please! Ring gear install question??? | 90'5.0 Conv | Windsor Power | 5 | 05-03-2002 07:53 PM |
| ring and pinion install kits?? | DemonGT | Windsor Power | 3 | 12-26-2001 05:47 PM |
| ring and pinion install | stanger8172 | Windsor Power | 5 | 03-25-2001 01:19 AM |
| Ring and Pinion 373's | roadrunner93 | Windsor Power | 5 | 01-23-2001 01:11 PM |