Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
05-31-2001, 03:05 PM
|
#3 |
|
Registered Member
Join Date: Apr 1999
Location: Hayes, Va, USA
Posts: 798
|
Yeah, I just spent about an hour at Autozone with my brother pouring over brake parts
 Lincoln Mark VII rotors will bolt up (same bearing sizes as the GT mustang with a 5 on 4-1/2 bolt circle and 11" rotor diameter) They are part number 5463 (Autozone) and are the ABS rotors. However the hub for the wheel is about a 1/4" bigger in dia than the Mustang's and possibly needs to be machined down as I'm almost certain that Ford's wheels like most manufacturer's are hub centric (meaning the hub is used to locate the wheel rather than the lugs) The rotors are about 80.00 bucks each, which isn't to bad I guess, I'm gonna get them payday and check things out. If they fit I'll take them to get the hub machined down and possibly cross-drilled (for that sexy look  ) |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
| Cross Drilled Rotors - Who uses them? | 2FastLX | Windsor Power | 6 | 09-29-2001 12:05 AM |
| Brake Rotors | 93GTDIN | Windsor Power | 6 | 09-06-2001 08:55 AM |
| Update on my scraping rotors | RMARIANI | Windsor Power | 0 | 09-05-2001 09:28 AM |
| Drilled front rotors | Danielz9 | Corner Carvers Delight | 3 | 06-14-2000 01:00 AM |