Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-03-2002, 08:47 AM
|
#20 |
|
or '331 LX Eric'
Join Date: Jan 1999
Location: Columbus, Ohio
Posts: 2,142
|
Chris - As I was ordering my 331 kit, I was screwing around with numbers trying to figure out how to calculate the volume of a cylinder when I remembered the following formula for volume (regardless of block type
 )Formula for volume of a cylinder = Pi x Diameter x Height Your calculation is pretty close say for a '306' Yours = 4.030^2 x 3.00 x .7853982 x 8 = 306.133767 Mine = 4.060 x 3.00 x Pi x 8 = 306.1167882 E
__________________
1991 5.0 LX Coupe - 40,750 miles 331 cu. in. / Tremec 3550 / BFG Drag Radials 12.22 @ 114.31 mph - w/1.89 60' |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building a stroker motor | Mustang_289 | Windsor Power | 4 | 02-17-2005 12:46 PM |
| Blown Stroker Computer Help | RabidPony | Modular Madness | 10 | 02-07-2004 11:56 PM |
| 'super' stroker vs 'budget' stroker | mike5p01 | Windsor Power | 4 | 10-11-2003 10:11 PM |
| 351w or 347 stroker? which is better? | BLACK85GT | Windsor Power | 55 | 12-21-2002 06:52 PM |
| Decided to build a stroker, but where do I start? | WhiteLX | Windsor Power | 5 | 12-16-2002 10:35 AM |