Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
09-18-2002, 03:37 PM
|
#3 |
|
Registered Member
Join Date: Feb 2001
Location: Berkshire County - Massachusetts
Posts: 735
|
From '69 to '71 the 351W had a higher content of nickel but it's actual advantages have been disputed over the years. I think the determining factor is if you plan on using a roller cam & lifters or not. The pre-'75 blocks do not accept the roller lifter without an expensive retro-fit kit. I stayed away from it due to the price and went with a flat tappet hydraulic cam & lifter combo. Also, the early Mexican blocks had the highest nickel content of all Windsor's.
__________________
Red 1993 GT Street Machine Best E.T. - 12.41/Best MPH = 108 Engine is a 1969 351 block w/393 stroker kit. Dynamic Roller Myte C4, 8 pt cage. Edlebrock Performer heads and Victor Jr. EFI, FRPP 30lb injectors & Cartech fuel system. MSD ignition. Sothside Machine bars & Sub-frames, adj. upper's, 3.73's, Koni rear shocks, much more |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Need Throttle Body & Idle Conrol Valve Info | BigBobsL | Windsor Power | 2 | 02-10-2004 01:16 AM |
| Need some info | fastas69 | Windsor Power | 1 | 10-08-2003 04:23 PM |
| HELP!! Need INFO! | srv1 | Blue Oval Lounge | 6 | 09-12-2003 09:20 AM |
| rear diff. info. please | rokdog13 | Blue Oval Lounge | 3 | 02-07-2001 08:39 PM |
| Aftermarket 4.6 Heads & Manifolds & Blocks...WHERE ARE THEY!! got any ideas? | Shawn | Modular Madness | 3 | 09-26-2000 02:07 PM |