Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-08-2002, 11:21 PM
|
#2 |
|
Registered Member
Join Date: May 2002
Location: New Jersey
Posts: 375
|
there area few company's that make overdrive pulleys. I'm not sure what they are though. You may want to try to just put the stock pulley back on a see if it works. Also, if you getting another battery for some reason (all i can think of is a huge stereo) in which case you may want to think about upgrading to a sn95 135amp alternator. It means you can still use the underdrive pulley and maintain full charging capacity.
__________________
'89 LX 5.0, off-road h pipe, flowmaster muffs, underdrive pulleys, rebuilt WC T-5, King Cobra Clutch, 65mm throttle body, Explorer Upper/GT40 lower, Lakewood Rear Lift Bars. 76mm C&L Mass air w/ inlet pipe, Twisted wedge heads w/ stage 2 port,polish, MAC equal length shorties, Billet AFPR, 255LPH fuel pump, fresh low end w/ 10.5:1 compression. If anyone ever wants to go to Raceway Park in Englishtown New Jersey, give me a shout. RICER HATERS CLUB MEMBER 87! www.ricehatersclub.com |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 68 Mustang Engine Swap pulley problems | kirkdickinson | Classic Mustangs | 10 | 07-13-2008 07:45 PM |
| Battery is dead after pulley install?!? | Stang_Crazy | Windsor Power | 16 | 02-07-2002 09:39 PM |
| My Friend, Tim C, let me DRIVE HIS CAR!!!! | Mercury | Blue Oval Lounge | 0 | 10-13-2001 01:25 AM |
| Dont 99+ GT's have Alunimum drive shafts? | Mercury | Modular Madness | 5 | 05-15-2001 12:33 PM |
| Piggyback pulley problems! (long) | Mustang92 | Modular Madness | 3 | 01-16-2001 10:24 PM |