Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
11-16-2002, 12:30 AM
|
#9 |
|
Registered Member
Join Date: Jun 2002
Location: Southern California
Posts: 109
|
so shaggy, is there a whole lot more for me to do, rather than just removing the old stuff, and putting on the new? What kinda tricky stuff with the distributor will i have to do? And do i have to buy "Ford kickdown linkage" separate for the edelbrock carb???
Im probably gunna need some help with this lol
__________________
 1973 Mustang Coupe 351 cleveland 2v heads Edelbrock Performer Intake, Holley 600cfm carb Hooker Headers, 2.5 inch pipes, Magnaflow X-pipe, Flowmaster 2 chamber mufflers with turndowns. Stock Fmx tranny and 2.75 rear end My website:http://www.geocities.com/spddemontc User Rides Index: http://www.mustangworks.com/cgi-bin/...splay.cgi?2541 |
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| TFS Intake manifold | Hozer 88GTConv | Windsor Power | 1 | 10-15-2004 03:47 PM |
| intake manifold cracked on my 97 GT-help! | jinx6570 | Modular Madness | 4 | 12-23-2002 03:28 AM |
| Power Gains w/ new intake manifold??? | Blaster | Windsor Power | 2 | 10-14-2001 01:59 AM |
| intake manifold selection | yusuf | Windsor Power | 0 | 03-05-2001 04:07 AM |
| 96 to 99 intake manifold swap? | T-Bone | Modular Madness | 2 | 05-13-2000 12:13 AM |