Threaded Mode
© Copyright 1995 thru 2008 - The Mustang Works™. All Rights Reserved.
MustangWorks.com is designed and hosted by Aero3 Media.
MustangWorks.com is designed and hosted by Aero3 Media.
07-02-2001, 11:20 PM
|
#3 |
|
Registered Member
Join Date: Feb 2000
Location: Flemington, NJ USA
Posts: 166
|
I am running the GT40 irons on my supercharged 302. The machine shop work has been pretty extensive (porting, polishing, 3 angle, o-rings, cut for loc wire gaskets). The car is making 403 @ the wheels with these heads and many other mods. I am happy with the performance, but would go with aluminums when I do it again. Trick Flow makes a good head at low cost. You may want to check them out. I would definitely go with aluminum.
|
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| is there a visual diff. between the stock e7 and gt 40 iron heads | 93calcobra | Windsor Power | 3 | 11-05-2002 09:58 AM |
| will 99-2002 cams out of the pi heads fit in the 96-98 stock heads | slow98 | Modular Madness | 6 | 10-25-2002 04:28 PM |
| 351W heads on 289? | 66 Racer | Classic Mustangs | 4 | 10-18-2001 03:12 AM |
| GT and LS-1 get into Tangle. GT WINS!! | Mercury | Stang Stories | 8 | 06-26-2001 12:49 PM |
| is there any difference between 351C heads and 351M heads | tireburner163 | Windsor Power | 7 | 03-09-2001 09:26 PM |